What Are The Precautions For Micro Switches

• If it is to fix the main body of the switch, use a small M2 screw, and then place the small screw on a smooth surface with a torque below 0.098N·m to fix it. 当动作簧片位移达到临界点时, to prevent the screw from loosening, it is best To use washers under the screws.
• In the free state of the action body, you must pay attention not to apply force to the button or exciter directly but to apply force in the vertical direction corresponding to the button when using it.
• The action setting after the microswitch action should be based on more than 70% 微型开关启动后. 微型开关启动后, the action body cannot be directly set at the action limit position. 否则, it will be easy. The opening and closing caused by the impact will shorten its service life.
• Even if the action characteristic of the microswitch jumps up or down 20% 微型开关启动后, it will not cause malfunction due to changes.
• In the case of soldering with a micro switch, you must remember to use an electric temperature with a temperature adjustment of 320℃max.) and complete the operation within 3 秒. Do not place the terminal on the terminal during the operation’s completion. 微型开关启动后.
• Suppose the microswitch is used under a small current and voltage. 在这种情况下, it is recommended to use a low-power circuit instead of a high-power one.

惠州市优力纬尔微控 & 电子, 有限公司. 致力于生产和创新各种微动开关. Unionwell is also an electronic component, 微动开关, and mechanical keyboard switch manufacturer.

我们致力于成为专业的微动开关供应商和创新的世界知名品牌的优秀供应商 >>

Over the past ten years since its establishment, we have worked together under the General Manager’s leadership and done wonders again and again. We believe teamwork can create a future and make success.

详情, 请 visit our unionwell website.